Juniper PTX3000 Hardware Manual page 98

3. Using both hands, place the power supply in the power supply slot on the FRU panel of the optical ILA
and slide it in until it is fully seated and the locking lever slides into place.
Figure 30: Installing an AC Power Supply in an Optical ILA
Figure 31: Installing a DC Power Supply in an Optical ILA
See "Connecting AC Power to an Optical ILA" on page 63
DC Power to an Optical ILA" on page 66
NOTE: Each power supply must be connected to a dedicated power source outlet.
NOTE: If you have a Juniper Care service contract, register any addition, change, or upgrade of
hardware components at https://www.juniper.net/customers/support/tools/updateinstallbase/.
Failure to do so can result in significant delays if you need replacement parts. This note does
not apply if you replace existing components with the same type of component.
to connect the AC power supply. See
to connect the DC power supply.
98
"Connecting