Juniper PTX3000 Hardware Manual page 80

Table 27: System Configuration Commands (Available in both Auto Mode and Manual Mode) (continued)
Command
snmp-trap-destination delete-v1/v2 ip1 port1 ipN portN
snmp-user add-v1/v2c (1 | 2) (trap | notrap) ipaddress
port community (r | w)
snmp-user add-v3 (trap | notrap) ipaddress port community
(r | w) engineid (AuthPriv | AuthNoPriv |
noAuthNoPriv)(MD5 | SHA) authkey (DES | AES) privkey
snmp-user delete-v1/v2c (1 | 2) ipaddress community
snmp-user delete-v3 ipaddress community
set ila-mode (auto | manual)
set log-size x
Description
Deletes an SNMP V1/V2c user.
ip: The IP address.
port: The SNMP port number. The port range is
0–65,535.
N: The range is 1–5 SNMP users.
Adds an SNMP V1/V2c user.
1 | 2: Enter version 1 or 2.
ipaddress: The IP address.
port: The SNMP port number. The port range is
0–65,535.
community: The range is 6-15 characters.
r | w: Read or read/write.
Adds an SNMP V3 user.
ipaddress: The IP address.
port: The port range is 0–65,535.
community: The range is 6–15 characters.
engineid: The range is 10–128 hexadecimal characters.
authkey: The range is 8–15 characters.
privKey: The range is 8-15 characters.
Deletes an SNMP V1 V2 user.
1 | 2: Enter version 1 or 2.
ipaddress: The IP address.
community: The range is 6–15 characters.
Deletes an SNMP V3 user.
ipaddress: The IP address.
community: The range is 6–15 characters.
Sets the mode. In auto mode, the software adjusts the
EDFA gain and VOA attenuation automatically by using
the OSC data. The default is auto.
Sets the size of the log file.
x: Enter a value from 1–10, and the unit is MB.
80