Juniper PTX3000 Hardware Manual page 73

Table 24: CLI System show Commands (Available in both Auto Mode and Manual Mode) (continued)
Command
show snmp-user
show alarm
show fan-status
show uptime
show ila-mode
show log-cfg
show alarm-cfg
show time
show power-status
show upgrade-status
show run-time
Table 25 on page 73 describes the optical show commands. These commands provide information about
the erbium-doped fiber amplifier (EDFA) properties.
NOTE: There are two EDFAs in the optical ILA: one is responsible for A to B direction (for
example, east to west) and is called E-ab; the other one is responsible for B to A direction (for
example, west to east) and is called E-ba. These options are displayed in many of the show edfa
commands in Table 25 on page
Table 25: Optical show Commands (Available in both Auto Mode and Manual Mode)
Command
show edfa-mfg
Description
Displays the SNMP user information.
Displays the current alarms. See
and their descriptions.
Displays all three fan speeds.
Displays the time from the startup of the optical ILA to the current time.
Displays the current optical ILA mode. It is either manual or auto.
Displays the log file path in Secure File Transfer Protocol (SFTP), the maximum
size of the log file, the SFTP username, and the user password.
Displays the optical ILA alarm configuration.
Displays the system time.
Displays the AC and DC power status.
Displays the software upgrade status.
Displays the optical ILA run time, how many hours the ILA has been running.
73.
Description
Displays the EDFA's manufacturing information, such as model number,
serial number, boot version, hardware version, and so on.
Table 32 on page 106for a list of the alarms
73