Juniper PTX3000 Hardware Manual page 89

Ensure that you have the following parts and tools available to power off the optical ILA:
An ESD grounding strap
An external management device such as a PC
An RJ-45 to DB-9 rollover cable to connect the external management device to the console port
To power off an optical ILA by using the shut CLI command:
1. Connect to the device by using one of the following methods:
Connect a management device to the console (CON) port on an optical ILA by following the instructions
in "Connecting the Optical ILA to a Management Console" on page
Connect a management device to the management (MGMT) port by following the instructions in
"Connecting the Optical ILA to a Management Ethernet Device" on page
2. Shut down the optical ILA by using the shut CLI command. This command shuts down the optical ILA
and powers off the unit.
CAUTION:
BPS->shut down
Shutting down this ILA will affect the traffic in both directions and require
someone to physically turn on the system. Do you want to continue (y/n) [n]:
Enter y to shut down the ILA.
3. To prevent damage to the equipment caused by static discharge, attach an ESD grounding strap to
your bare wrist, and connect the strap to one of the ESD points on the chassis.
4. Disconnect power to the optical ILA:
AC power supply—If the AC power source outlet has a power switch, set it to the off (O) position. If
the AC power source outlet does not have a power switch, gently pull out the plug end of the power
cord connected to the power source outlet.
DC power supply—Switch the circuit breaker on the panel board that services the DC circuit to the
off position.
5. Remove the power source cable from the power supply faceplate:
AC power supply—Gently pull out the socket end of the power plug connected to the power supply
faceplate.
The following message is displayed when you enter the shut command.
59.
58.
89