CAUTION:
wiring must be shielded, and the shield for the wiring must be grounded at both ends.
WARNING:
connection to intrabuilding or unexposed wiring or cabling only. The intrabuilding ports
of the equipment or subassembly MUST NOT be metallically connected to interfaces
that connect to the Outside Plant (OSP) or its wiring. These interfaces are designed
for use as intrabuilding interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE, Issue 4) and require isolation from the exposed OSP cabling. The
addition of primary protectors is not sufficient protection in order to connect these
interfaces metallically to OSP wiring.
RELATED DOCUMENTATION
General Electrical Safety Guidelines and Electrical Codes for Juniper Networks Devices
Agency Approvals and Compliance Statements
IN THIS SECTION
Optical ILA Agency Approvals | 171
Compliance Statements for EMC Requirements | 172
Compliance Statements for Environmental Requirements | 173
Compliance Statements for NEBS | 173
Optical ILA Compliance Statements for Acoustic Noise | 174
To comply with intrabuilding lightning and surge requirements, intrabuilding
The intrabuilding ports of the equipment or subassembly are suitable for
170