Optical Ila Cli Upgrade Commands - Juniper PTX3000 Hardware Manual

Table 29: TCA Default Values (continued)
TCA
EDFA pump temperature (for both EDFAs, 2 pumps per
direction)
edfa-ab-pump0-temperature
edfa-ba-pump0-temperature
edfa-ab-pump1-temperature
edfa-ba-pump1-tempe rature
Power monitor at input port
Power monitor at output port
NOTE: No fixed value for the EDFA pump current TCA-high limit. The software reads the EOL value for the individual
EDFA pump from an EEPROM and applies it where it is needed.

Optical ILA CLI Upgrade Commands

Table 30 on page 85 describes the upgrade commands for the optical ILA. Use these commands to upgrade
the optical ILA software image in both auto mode and manual mode.
Table 30: CLI Upgrade Commands (Available in both Auto Mode and Manual Mode)
Command
upgrade image-name
ftp-upgrade a b c d e
Description
Upgrades the optical ILA. The image name is the name of the package.
Downloads the image from an FTP server and upgrades the optical ILA. After the update
is complete, enter the reboot command to restart the optical ILA.
a: FTP server IP address.
b: FTP server port; the port range is 0–65535.
c: FTP username; the length is 4–16 characters.
d: FTP password; the length is 4–16 characters.
e: FTP image path and name; the length is 1–50 characters.
Unit TCA-High
degrees (C) 30
dBm 12
dBm 21
85
TCA-Low
20
–38
–13