Optical Ila Cli System Commands - Juniper PTX3000 Hardware Manual

NOTE: No message is displayed to state these commands (listed in the
Commands" on page
Commands in the following section can only be issued in manual mode:
Optical ILA CLI Debug Commands on page 86

Optical ILA CLI System Commands

Table 23 on page 71 describes the system-level commands for the optical ILA. You can use these commands
to perform system-level functions in both auto mode and manual mode.
Table 23: System Commands (Available in both Auto Mode and Manual Mode)
Command
history
clear
help
logout
login
shell
reboot (soft | hard)
exit
86) issued in auto mode are not effective.
Description
Displays the command history.
Clears the screen.
Displays the description of interactive help system.
Returns to the CLI mode from the admin mode.
Logs in to the admin mode.
Logs in to the shell mode.
Reboots the Linux system.
After a hard reset, the settings revert to the default values.
After a soft reset, the optical ILA's setting is recovered to the state before the reset.
If you have not logged in to the admin mode, the exit command exits the CLI and takes
you back to original Linux shell. If you have logged in to the admin mode, the exit
command logs you out and takes you to the CLI mode.
"Optical ILA CLI Debug
71