Optical Ila Modes Of Operation - Juniper PTX3000 Hardware Manual

3. Start the CLI.
root@localhost:~# /usr/bin/command
Welcome to ILA World
BPS>
4. To enter administration mode, log in as the root user with the password Admin@123.
BPS>login
Username: root
Password: *********
Completed!
BPS>
5. Use the CLI console commands to configure, monitor, and troubleshoot the optical ILA.

Optical ILA Modes of Operation

There are two modes of operation for the optical ILA:
Auto mode (default mode). This is the standard operating mode of the optical ILA. Commands issued in
the auto mode do not alter the optical behavior of the ILA. Commands in the following sections can be
issued in auto mode:
Optical ILA CLI System Commands on page 71
Optical ILA CLI show Commands on page 72
Optical ILA CLI Configuration Commands on page 78
Optical ILA CLI Upgrade Commands on page 85
Manual mode–this mode should only be used to debug the optical ILA. If the commands listed in the
"Optical ILA CLI Debug Commands" on page 86
These commands alter the optical behavior of the ILA.
are issued in the auto mode they do not become effective.
70