Removing A 2.5 Inch Drive From The 3.5 Inch Drive Adapter; Installing A 2.5 Inch Drive Into The 3.5 Inch Drive Adapter - Dell EMC PowerEdge R7425 Installation And Service Manual

Removing a 2.5 inch drive from the 3.5 inch drive adapter

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove 3.5 inch drive adapter from the 3.5 inch drive
NOTE: A 2.5 inch hot swappable drive is installed in a 3.5 inch drive adapter, which is then installed in the 3.5 inch hot swappable
drive carrier.
Steps
1 Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5 inch drive adapter.
2 Remove the drive from the 3.5 inch drive adapter.
Figure 50. Removing a 2.5 inch drive from the 3.5 inch drive adapter
Next step
Install a 2.5 inch drive into the 3.5 inch drive

Installing a 2.5 inch drive into the 3.5 inch drive adapter

Prerequisite
Follow the safety guidelines listed in
Steps
1 Align the screw holes on the 2.5 inch drive with the screw holes on the 3.5 inch drive adapter.
2 Using a Phillips #2 screwdriver, install the screws to secure the drive to the 3.5 inch drive adapter.
Safety instructions.
Before working inside your
carrier.
adapter.
Safety instructions.
system.
Installing and removing system components 93