Certifications; Ce-Marking; Ul / Cul - Marking - KEB COMBIVERT F5 Installation Manualline

Certifications

6. Certifications
6.1

CE-Marking

CE marked frequency inverter and servo drives were developed and manufactured to
comply with the regulations of the Low-Voltage Directive 73/23/EEC.
The inverter / servo drive must not be started until it is determined that the installation
complies with 89/392/EEC (machine directive) as well as the EMC-directive (89/336/
EEC)(note EN60204).
The frequency inverters / servo drives meet the requirements of the Low-Voltage Directive
73/231/EEC. The harmonized standards of the series EN 50178 in connection with EN
60439-1 and EN 60146 were used.
This is a product of limited availability in accordance with IEC 61800-3. This product may
cause radio interference in residential areas. In this case the operator may need to take
corresponding measures.
6.2

UL / CUL - Marking

C
• Inverter is suitable for use on a circuit capable of delivering not more than 10 kA rms
(symmetrical), 240 V AC or 480 V AC maximum
• Maximum surrounding air temperature 45 °C (113 °F)
• For control cabinet mounting as „Open Type"
• For use in a pollution degree 2 environment
• Motor protection by adjustment of current parameters
• Not incorporated with overspeed protection
• Power terminal tightening torque (see type plate)
• Control terminal tightening torque (see chapter 3.4)
• Overload protection at 130 % of inverter output rated current (see type plate)
• Refer to this installation instructions for proper wiring
To be conform according to UL and CUL for the use on the North
American and Canadian Market the following instructions must be
observed:
27