IBM Netfinity ServeRAID-4H Ultra160 User Reference page 58

10. When prompted to select a device driver to install, select IPSRAID.HAM.
11. Click Yes when prompted to copy the IPSRAID.HAM driver.
12. When the prompt appears to specify the server boot path, type:
13. After the installation program copies all files, you can edit parameters (such as
14. After you edit the parameters, click Save Parameters and load driver to load
15. Press Esc to exit from the installation screens.
Note: If you want NetWare to load the ServeRAID device driver automatically
Updating device drivers for Red Hat Linux 6.1 (or later)
This section provides instructions for updating the ServeRAID device drivers from
CD-ROM, diskette, and the World Wide Web. You can update the device drivers if
Linux is already installed or when updating previous device drivers.
Updating device drivers after installing Linux: Before proceeding, you must
already have installed Red Hat 6.1 Linux distribution on your server. This set of
instructions assumes the following:
v You already have a Red Hat 6.1 Linux operating system installed.
® ®
44
IBM Netfinity User's Reference: ServeRAID
where d is the CD-ROM drive letter.
v For NetWare 5.x: If you are installing from diskette, type:
a:\netware5
where a is the diskette drive letter.
v For NetWare 5.x: If you are installing from CD-ROM, type:
d:\programs\netware\driver\netware5
where d is the CD-ROM drive letter.
c:\nwserver
Notes:
a. This instruction assumes that you installed NetWare in its default directory.
If you did not install NetWare in the NWSERVER directory on drive C,
modify step 12 on page 44 accordingly.
b. If any of the files you are installing already exist on the server, NetWare will
prompt you to save the older files. Although it is not necessary to save the
older files, it might be useful to do so.
the ServeRAID slot number) from the Driver IPSRAID Parameter Actions
window.
the ServeRAID device driver.
Note: If the device driver is not installed already and the operating system is
installed, an error message stating that the device driver failed to load
should appear after you complete the previous step. If that happens, do
the following:
a. Press Esc to exit from the installation screens.
b. Shut down the server.
c. Restart the server by typing the following at the system prompt:
server
d. The server automatically loads and installs the device driver.
during startup, you must add the appropriate LOAD command (for example,
load ipsraid.ham slot=1) to the NetWare startup command file (usually
C:\NWSERVER\STARTUP.NCF).
™
-4H Ultra160 SCSI Controller