IBM Netfinity ServeRAID-4H Ultra160 User Reference page 55

d. Select Advanced Functions from the Main Menu.
e. Select View Controller and PCI Information from the Advanced Functions
menu.
f. Record the slot number for the ServeRAID controller; then, press Esc three
times to return to the controller-selection screen.
g. Repeat step 3c on page 40 through step 3f until you record the slot number
for each ServeRAID controller that appears on the selection screen.
4. Turn off the system; then, remove all ServeRAID, IDE, and SCSI disk-storage
adapters and controllers except the one attached to the drive where you intend
to install UnixWare.
Note: If one of the disk-storage or ServeRAID controllers that you need to
remove is on the system board, do one of the following:
v If the CD-ROM drive that you are using to install your operating
system is attached to the integrated controller, disconnect or remove
all disk drives attached to the integrated controller.
v If only disk drives are attached to the integrated controller, disconnect
the SCSI or IDE cable for the integrated controller from the connector
on the system board. See the label inside the server cover for the
location of the SCSI and IDE cable connectors.
5. Follow the instructions in "Installing the files while installing UnixWare"; then,
return here and continue with step 6.
6. Turn off the system.
7. Install any non-ServeRAID disk-storage adapters or controllers in the server;
then, attach the drives to the disk-storage adapters and controllers.
8. Install the first ServeRAID controller from the list you created in step 3f; then,
attach the drives to the ServeRAID controller.
9. Turn on the system and allow UnixWare to detect the new disk-storage adapters
and controllers.
10. Turn off the system.
11. Repeat steps 8 on page 41 through 10 on page 41 until all ServeRAID
adapters, ServeRAID controllers, and drives are installed.
12. You can now partition and format the logical drives attached to the ServeRAID
adapters and controllers. See the information provided with UnixWare for more
instructions.
Installing the files while installing UnixWare: To install the ServeRAID files
while installing UnixWare 7.1:
1. Use the instructions provided with UnixWare to begin the installation.
2. When a message appears asking if you want to install any HBA diskettes, insert
the IBM ServeRAID Device Drivers for SCO Operating Systems - UnixWare
HBA and OpenServer BTLD diskette; then, select Install HBA diskette.
3. Use the instructions provided in the UnixWare manual to complete the normal
installation process.
Chapter 2. Installing and configuring ServeRAID controllers
41