Updating Serveraid Software In An Mscs Cluster Environment; Step 1: Upgrading The Ibm Serveraid Manager Program; Step 2: Upgrading The Ibm Serveraid Microsoft Windows Nt Cluster Solution - IBM Netfinity ServeRAID-4H Ultra160 User Reference

10. After the server has restarted, click Start; then, click Settings → Control
11. Double-click Add/Remove Programs.
12. Select IBM ServeRAID Windows NT Cluster Solution from the list of
13. Repeat step 1 on page 89 through step 12 on page 90 for the other server in

Updating ServeRAID software in an MSCS cluster environment

Note: If you are upgrading your ServeRAID software after downloading it from the
Note: Use these instructions on a cluster running Microsoft Cluster Service (MSCS)

Step 1: Upgrading the IBM ServeRAID Manager program

To upgrade the ServeRAID Manager program, run the SETUP.EXE program on the
IBM ServeRAID Support CD.
Step 2: Upgrading the IBM ServeRAID Microsoft Windows NT Cluster
Solution
To upgrade the IBM ServeRAID Microsoft Windows NT Cluster Solution, do the
following on each server in the cluster:
1. Start the Microsoft Cluster Administrator program on the server you want to
2. Insert the IBM ServeRAID Support CD into the CD-ROM drive; then, type the
3. Follow the instructions that appear on the screen.
® ®
90
IBM Netfinity User's Reference: ServeRAID
Note: Ignore the warnings regarding the removal of IBM ServeRAID Logical
Disks.
8. Follow the on-screen prompts by clicking OK or Yes.
9. After the uninstallation of MSCS is complete, restart the server when
prompted.
Panel.
installed components; then, click Add/Remove.
the cluster.
IBM Support Web site, perform this procedure. If you are installing your
software using the IBM ServeRAID Support CD, refer to "Chapter 2.
Installing and configuring ServeRAID controllers" on page 13 for instructions.
Important
This upgrade procedure allows the cluster to remain online at all times. To upgrade the
cluster, perform the following steps on one server at a time. When all steps are completed
for Server A and both servers are reported in the Microsoft Cluster Administrator program as
up and all resources are online, repeat the steps for Server B.
Release 1.00 and IBM ServeRAID Cluster Solution.
upgrade and move all resources and groups to the other server (its cluster
partner).
following command and press Enter.
d:\programs\winnt\cluster\setup.exe
where d is the CD-ROM drive.
™
-4H Ultra160 SCSI Controller