IBM Netfinity ServeRAID-4H Ultra160 User Reference page 37

ServeRAID controller settings after you have configured the ServeRAID controller
and installed the operating system. Refer to "Using Information mode" on page 33
for additional information.
The ServeRAID Manager program runs in two modes: Configuration mode and
Information mode.
In Configuration mode, you can create disk arrays, create logical drives, and define
your hot-spare drives. When this mode is active, a limited set of functions is
available from the menu and tool bars. See "Using Configuration mode" on page 25
for more information.
In Information mode, you can view and modify the existing device and configuration
information for your ServeRAID subsystem. When this mode is active, you can use
the functions available from the menu and tool bars to customize settings for your
ServeRAID controllers. See "Using Information mode" on page 33 for more
information.
To start the ServeRAID Manager program, do the following:
1. Insert the IBM ServeRAID Support CD (or the CD that contains the ServeRAID
Manager program that came with your system) into the CD-ROM drive; then,
turn on the server.
One of the following windows will open:
v If the ServeRAID Manager program detects unconfigured ServeRAID
controllers, the program starts in Configuration mode and a window similar to
the following opens.
Chapter 2. Installing and configuring ServeRAID controllers
23