IBM Netfinity ServeRAID-4H Ultra160 User Reference page 33

Figure 2. Inserting a ServeRAID-4H controller into the PCI expansion slot
10. Connect one end of a 68-pin ANSI standard cable (separately purchased or
2. ANSI stands for American National Standards Institute.
8. Secure the controller by either tightening the expansion-slot screw on the top
of the controller or closing the latch, depending on your server.
9. Connect the SCSI cables to the controller. If you intend to attach external
devices only, go to step 13 on page 20. Otherwise, continue with step 10
already in your server) to the internal channel connector on the ServeRAID
controller.
Note: See "Connector locations" on page 15 for the channel connector
locations.
Chapter 2. Installing and configuring ServeRAID controllers
19