O2 Supply Specifications; Ventilation Performance And Controlled Parameters - GE iVent 201 Series User's Reference Manual

O2 SUPPLY SPECIFICATIONS

Parameter
High Pressure
Low Pressure
VENTILATION PERFORMANCE AND CONTROLLED
PARAMETERS
Parameter
Respiratory Rate
Tidal Volume
Accuracy of Tidal Volume
Delivery
Accuracy of Exhale Tidal
volume Measurement
Inspiratory Pressure Limit
Inspiratory Time
Peak Flow (PIF)
Oxygen Mix (FiO
PEEP
Trigger Sensitivity
PSV
Positive Pressure Relief
Valve
Pneumatic Nebulizer
Controlled Pressure
FiO at Power up
2
Configurable Humidifier
Setting (Purging Cycle)
Pressure Range 40 –75psi (2.8-5.1 bar).
Warning: The exact oxygen pressure which the
iVent 201 uses depends on the version you
TM
have. Check the back label (shown in Figure 11)
for the pressure levels of your unit.
Maximum flow 15L/min or 0.5 psi
1 – 12 ±1, 12 – 80 ± 2 bpm
50-2000 mL
±10% or ±10 mL whichever is greater
±15% above 100 mL from actual reading
or ±10 cc below 100 mL
5 to 80 ±5 cmH
Adaptive Time
Adaptive Flow
Spontaneous to 180 ±10% L/min
) 21% to 100% ±10% of the set value or ±3%
2
absolute, whichever is greater
0 to 40 ±1 cmH
greater
1 to 20 L/min Flow, Off
- 0.5 to – 20 cmH
0 to 60 ±10% cmH
80 cmH O
2
5 to 240 minutes
5 to 80 cmH O ±5 cmH
2
21%, 40%, 60%, 100% (configurable)
HME (10 minute), Heated (1 minutes), Off
17
O
2
or 0.2 to 3 ±10% sec
TM
or to 120 ±10% L/min
TM
O or ±10%, whichever is
2
O Pressure, Off
2
O
2
O
2
1 Introduction