Roll Stand; Mounting The Ivent Tm 201 On The Roll Stand; Dismounting The Ivent Tm 201 From The Roll Stand - GE iVent 201 Series User's Reference Manual

ROLL STAND

NOTE
MOUNTING THE IVENT
WARNING
WARNING
DISMOUNTING THE IVENT
3. Connect the Patient circuit to the iVent
4. Insert the patient circuit into the twin tube holder, as shown in Figure 196
5. Use the latches on the Support Arm, shown in Figure 197, to adjust the
Support Arm to the meet the patient and the healthcare needs
The Roll Stand Accessory is used for mounting the iVent
a standard mounting bracket is installed.
This Roll Stand is compatible with the iVent
iVent 201 ventilator "yellow".
TM
The iVent 201 MRI Roll Stand is an MR conditional accessory which poses
TM
no known hazards in a specified MR environment with specified conditions
of use as per F 2503-05.
TM
201 ON THE ROLL STAND
Make sure that the patient is not connected to the ventilator and that the
device is in Standby mode, or shut down.
1. Verify that the standard Transport Mounting Plate M1169908 (Figure 198
(1.1A)) or a Plate Cart Adapter M1161827 (Figure 198(1.1B)) is connected to
the ventilator
2. Lock all roll stand casters using the casters' breaks.
3. Pull the locking pin and hold it while sliding the iVent
Mounting Plate into place.
4. Release the locking pin and verify that the mounting plate is locked to the
mounting bracket, and the locking pin is placed inside the hole.
Slide the device carefully! When the locking pin is pulled, the device may
slide out all the way without stopping.
5. Tighten the mounting bracket screws to lock the transport mounting plate
place
201 FROM THE ROLL STAND
TM
201 device as described in page 40.
TM
201 ventilator "grey" and with the
TM
262
201 ventilator, in which
TM
201 with the Transport
TM