Volkswagen Passat 2011 Workshop Manual page 53

2.1.2 Assembly overview - rear brakes, CII 41
Note
Use the brake filling and bleeding equipment - VAS 5234- to
♦
draw off brake fluid from the brake fluid reservoir.
Before removing a brake caliper or disconnecting a brake
♦
hose, fit brake pedal depressor - V.A.G 1869/2- (when doing
this, release pressure in system).
1 - Splash plate
❑ Allocation ⇒Electronic
Parts Catalogue (ETKA)
2 - Brake disc
❑ ∅ 310 mm
❑ Thickness: 22 mm
❑ Wear limit: 20 mm.
❑ When worn, renew on
both sides of axle.
❑ Remove brake caliper
and brake carrier prior to
removing.
3 - Torx socket head bolt, 4 Nm
4 - Multi-point socket head bolt,
90 Nm and turn 90° further
❑ Renew after removing
❑ Remove and install us‐
ing socket insert -
T10035- ⇒ page 50
5 - Brake carrier with guide pin
(s) and protective cap
❑ Supplied as genuine
part, assembled with
sufficient grease on
guide pins.
❑ If protective caps or
guide pins are dam‐
aged, install repair kit.
Use lubricant sachet
supplied to lubricate
guide pins.
6 - Anti-rattle spring
❑ Always renew when
changing pads.
7 - Brake pad
❑ Thickness: 11 mm not including backplate.
❑ Wear limit: 2 mm not including backplate.
❑ Checking thickness ⇒ Maintenance ; Booklet ; Front and rear brake discs and pads: Checking condition
of discs and thickness of pads
❑ Always renew on both sides of an axle.
❑ Removing and installing
8 - Brake pad
❑ Thickness: 11 mm not including backplate.
.
⇒ page 50
Passat 2011 ➤ , Passat Variant 2011 ➤
Brake systems - Edition 02.2014
49
2. Rear brakes