1
Indoor Unit
SELECTING THE INSTALLATION SITE
Type E1
1. S-160PE1R5B
AVOID:
areas where leakage of fl ammable gas may be expected.
●
places where large amounts of oil mist exist.
●
direct sunlight.
●
locations near heat sources which may affect the
●
performance of the unit.
locations where external air may enter the room directly. This
●
may cause "condensation" on the air discharge ports, causing
them to spray or drip water.
locations where the remote controller will be splashed with
●
water or affected by dampness or humidity.
installing the remote controller behind curtains or furniture.
●
locations where high-frequency emissions are generated.
●
DO:
select an appropriate position from which every corner of the
●
room can be uniformly cooled.
select a location where the ceiling is strong enough to
●
support the weight of the unit.
make sure to install protective guards on the suction and discharge side
●
to prevent somebody from touching the fan blades or heat exchanger.
select a location where tubing and drain pipe have the
●
shortest run to the outdoor unit.
allow room for operation and maintenance as well as
●
unrestricted air fl ow around the unit.
the limitation of the tubing length between the indoor and the
●
outdoor units should be referred to the Installation Instructions
of the outdoor unit.
allow room for mounting the remote controller about 1m off
●
the floor, in an area that is not in direct sunlight or in the flow
of cool air from the indoor unit.
Fig. 1-11-2-1-1
1-11-2-1-1