Panasonic S-160PE1R5B Technical Data & Service Manual page 266

2. Wireless Remote Controller
2. Installing the Receiver
1
Remove the bottom case.
2
Mount to the wall.
Preparation: Make 2 holes for screws using a driver.
3
Mount the top case.
 Align the claws of
the top case and
then align the claws
of the bottom case.
Cut here with a
nipper and remove
the burr with
8
Bottom case (Back side)
Insert the driver
and slightly turn.
Bottom
case
E x p o s e d y t p e
1
Mount the bottom case
to the wall.
f a . e l i
Claw (2 places)
W l l a o t
receiver
Claw
Hole for screw
Wood screw (supplied)
2
Connect the remote controller wiring.
 Arrange the wires along the groove of the case.
Clamper
(supplied)
Pass through
the hole.
Remove the coating. Approx. 6 mm
Top case
Remove the sheath. Approx. 150 mm
(Back side)
Make sure the wiring connection
is in the correct direction.
Attention
Mounting the bottom case
 Tighten the screws securely until the screw
heads touch the bottom case.
(Otherwise, loose screw heads may hit the
PCB and cause malfunction when mounting
the top case.)
 Do not over-tighten the screws.
(The bottom case may be deformed, resulting
in fall of the unit.)
Connecting the remote controller wiring
Flat-blade
Arrange the wires as shown in the illustration for
screwdriver 
avoiding unnecessary wires being stored in the case. (Caught
wires may destroy the PCB.)
 Avoid wires touching parts on the PCB.
(Caught wires may destroy the PCB.)
Preparation: Make 2 holes for screws using a driver.
3
Mount the top case.
 Align the claws of
the top case and
then align the claws
of the bottom case.
Avoid the wire
being caught.
Claw (2 places)
x i f h t e
2
Bottom case (Back side)
8-30
2
E m b e d d e d y t p e
1
Mount the bottom case to
the wall.
 Pass the wire through the hole
in the centre of the bottom case.
Claw
Hole for screw
Wood screw (supplied)
Connect the remote controller wiring.
Terminal board
Remove the coating.
Approx. 6 mm
Top case
(Back side)
Make sure the wiring connection
is in the correct direction.
in step 2,