Panasonic S-160PE1R5B Technical Data & Service Manual page 259

2. Wireless Remote Controller
Matching up Addresses
Setting Remote Controller Addresses
1. If you press and
2. While holding down, every time you press
Set it to the receiver address switch of the indoor unit you wish to operate.
3. When you release
When you do this, if it corresponds to the receiver's address setting, the buzzer sounds.
Address
Display on the
Remote
Controller
CZ-RWSC3
Position of The position of the
the Receiver's receiver's address
Address Switch switch does not
matter.
NOTE
• Please do not hold the [Emergency Operation]
blinking one after another.
• Make sure to operate while the indoor unit is stopped.
• The address of indoor unit is set to "ALL" at the time of the shipment.
at the same time, " " will blink.
, the address that was displayed is set.
button of the indoor unit down while the indoor unit's display lamps are
, it cycles from ALL 1
8-23
Control of 2WAY SYSTEM
2 3... 6 ALL.
For 1, 2 and 3, set the switch on the
left and for 4, 5 and 6, to the right.
8