Panasonic S-160PE1R5B Technical Data & Service Manual page 49

1-9-3. Operating the High-spec Wired Remote
Controller (CZ-RTC5B)
[ ]
START
How to set the external static pressure
1. Keep pressing the
buttons simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the
LCD display.
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4.Test run
Sel. Page [
2. Press the or
menu. If you wish to see the next screen instantly,
press the or
Select "8. Detailed settings" on the LCD display
and press the button.
Maintenance func
5. Sensor info.
6. Servicing check
7. Simple settings
8. Detailed settings
Sel. Page [
The "Detailed settings" screen appears on the LCD
display.
Select the "Unit no." by pressing the
button for changes.
Detailed settings
Unit no. Code no.
3-1
Sel. Next
20:30 (THU)
, and
20:30 (THU)
] Confirm
button to see each
button.
20:30 (THU)
] Confirm
or
20:30 (THU)
Set data
10 0006
3. Select the "Code no." by pressing the
button.
Change the "Code no." to "5D" by pressing the
or
Detailed settings
Unit no.
3 1 -
Sel.
4. Select the "Set data" by pressing the
button.
Select one of the "Set data" among "0006", "0003"
or "0001" according to the desired external static
pressure setting by pressing the
button. (See Table 1-9-3 and Fig. 1-9-2.)
Then press the
Table 1-9-3 Setting the external static pressure
Indoor unit
180 200
External static pressure of the rated
air ow volume
150 Pa 180 Pa
100 Pa 120 Pa
60 Pa 75 Pa
5. Select the "Unit no." by pressing the
button and press the
The "Exit detailed settings and restart?" (Detailed
setting-end) screen appears on the LCD display.
Select "YES" and press the
Detailed settings
Exit detailed settings
Unit no.
1-1
Sel.
1-9-4
button (or keeping it pressed).
20:30 (THU)
Code no. Set data
5D 0 0 1 0
Next
or
button.
Item code
224
5D
200 Pa 0006
0003
130 Pa
0001
75 Pa
button.
button.
20:30 (THU)
Code no. Set data
and restart?
10 0001
YES NO
Next
1
or
or
or