Vertiv Liebert iCOM DP400/500 Installer/User Manual page 6

10.6 Configuring with the Start Up Wizard
10.6.1 To Update System Information Using the Wizard
11 Performing Diagnostics
11.1 Cooling Unit Status LED
11.2 Enabling Manual Mode for Diagnostics
11.2.1 Disabling Diagnostics Manual Mode
11.3 Diagnosing Evaporator Fan Issues
11.3.1 Diagnostics-Evaporator Fan Options
11.4 Diagnosing Compressor Circuit Issues
11.4.1 Diagnostics-Compressor Circuit Options
11.4.2 Resetting High Pressure Alarm Code
11.4.3 Resetting Low Pressure Alarm Code
11.4.4 Resetting High-temperature Alarm Counter
11.5 Diagnosing Electronic Expansion Valve Issues
11.5.1 Diagnostics-Electronic Expansion Valve Options
11.5.2 Resetting Electronic Expansive Valve Battery Failure Counter
11.6 Diagnosing EconoPhase Issues
11.6.1 Diagnostics-EconoPhase Options
11.7 Diagnosing Digital Output Issues
11.7.1 Diagnostics-Digital Output Options
11.8 Diagnosing Analog Output Issues
11.8.1 Diagnostics-Analog Output Options
11.9 Diagnosing Customer Input Issues
11.9.1 Diagnostics-Customer Input Options
12 Customizing Your iCOM Display
12.1 Setting General Display Properties
12.1.1 Unit Display Options
12.2 Customizing Main Display Views
12.2.1 Moving Content
12.2.2 Resizing Content
12.2.3 Adding and Adjusting Content
12.2.4 Removing Content
12.3 Customizing Parameter and Field Labels
12.3.1 Exporting, Importing, and Customizing Labels Using a Text Editor
13 Hardware Installation
13.1 Installing Wired Remote Sensors
13.1.1 Setting DIP Switches and Labeling 2T Sensors
13.1.2 Terminating the Last Sensor on the CANbus Link
13.1.3 Installing 2T Sensors in the Racks to Monitor
13.1.4 Connect the CANbus Cable and Ground
iv
94
94
95
95
95
96
96
96
97
97
98
98
98
98
99
100
100
100
101
101
101
101
101
101
103
103
103
104
104
104
105
106
106
108
110
110
110
112
115
117
Vertiv™ | Liebert® iCOM™ Installer/User Guide