Table of Contents
Advertisement
I
I
i
Ribbon Cassette Assembly Installation
L Grasp the ribbon cassette assembly and position it on the belt unit such that
the locating pins of the belt unit correspond to the locating holes of the
cassette. Take care to position the cassette lock correctly.
2. Lock the cassette.
Ribbon Inker Removal
The ribbon inker should be changed each time the ribbon is changed. Puncture
the ink pouch 24 hours before installation
to
allow the wick to become saturated
with ink.
L
Open the belt unit.
2. Slide the inker until both tabs at the top of the inker and the tab at the
bottom are free of the ribbon cassette.
3. Lift the inker and remove it from the cassette.
Rib bon Inker Installation
1. Remove the protective cap from the inker.
2. Position the inker at the top of the cassette, guiding the wick into the slot of
the cassette.
3. Lower the inker until its tabs are fitted into the cassette.
4. Close the belt unit.
Ribbon Refill Cartridge Removal
Operation
1. Remove the ribbon inker (see Ribbon Inker Removal).
2. Insert the ribbon comb (see Figure 3-10). This keeps the ribbon inside the
cartridge while the cartridge is removed.
3. Gently unlatch the
ink
roller assembly and pivot the assembly.
4. Unlatch the ribbon refill cartridge release tab at the right (Figure 3-9), lift the
cartridge from the right and remove it from the printer.
3-8
5182
CW99-00A
Advertisement
Table of Contents
