Section 2. Controls And Indicators; Main Control Panel - Honeywell PRU0901 Manual

Section
2
Controls and Indicators
This section describes the controls and indicators on the main control panel
and the control panel on the power stacker, as well as the mechanical controls
and adjustments on the printing mechanism.
Main Control Panel
The controls and indicators on the main control panel (Figure 2-1) are
described in Tables 2-1 and 2-2.
Table 2-1. Main Controls and Indicators (I)
ControJlIndicator
STOP/START
FORM FEED
READY
ALARM RESET
LINE FEED
Status
'Controls and Indicators
Function
This push button control changes the printer state from READY
(print orders are accepted from system) to STANDBY (stops
printing) or vice versa. The NORMAL indicator must be lit to go
into the READY state.
This push button control advances the paper to the top of the
next form. The printer must be in the STANDBY state.
This indicator is lit when the printer is in the READY
(operational) state.
This push button control must be pressed after a recoverable
fault or error is corrected. (The printer must be in the
STANDBY state.)
This push button control advances the paper one line. The
printer must be in the STANDBY state.
This indicator displays a two-digit hexadecimal code. A display
of 00 indicates that there is no problem; any other display alerts
the operator to operator correctable conditions or printer problems.
(See Appendix A for error codes.) During test execution the
display provide.s information about printer condition (see Section 5).
2-1
CW99-00