Opening The Belt Unit - Honeywell PRU0901 Manual

Operation
Figure
3-3.
Opening the Belt Unit
6. Slide the paper up through the paper path under the paper sensor bar,
behind the anti -smudge shield, and over the tractor pins until the paper
perforation is approximately aligned with the line indicator. (Refer to
Figure 3-4.)
7. Align the paper feed holes with the left tractor pins and close the left
tractor cover. Slide the right tractor until the paper feed holes are
aligned with the right tractor pins and close the right tractor cover. (Refer
to Figure 3-5.)
8. Position the paper horizontally by sliding both tractors along the shafts
and lock the left tractor. The optional horizontal fine adjustment screw
may be used for readjustment after paper tensioning.
9. Adjust the horizontal tension by sliding the right tractor and locking it.
Do not apply too much tension to the paper.
3-4
CW99-00