Table of Contents
Advertisement
Degree II Maintenance
Print Belt Cleaning·
1. Switch the printer-off at the circuit breakers.
2. Open the top cover and front door.
3. Open the belt unit and remove the ribbon cassette and anti-smudge shield.
4. Load paper between the paper tray and the. tractors, taking care that the
opening in the hammerbank guide plate is covered over the full length
0
5. U sing General Cleaner, clean the lower part of the belt fingers and the body of
the belt over a distance of about 10 cm (4 in.) as in Figure 4-1.
Figure4-1. BeltCleaning
6. Move the belt counterclockwise 10 cm and repeat the procedure until all the
lower belt fingers area is clean.
7. U sing the hard brush, clean the belt characters and fmger interspaces by
I
moving the brush vertically from top to bottom (see Figure 4-1) taking care
not to
d~age
the belt fingers.
Operator Maintenance
4-3
5182
CW99-00A
Advertisement
Table of Contents
