Polycom RealPresence Group Series Documentation page 50

Related Topics
Camera Presets in Single Camera Mode
Store a Camera Preset
You cannot delete a preset. Instead, overwrite an existing preset with a new camera position.
Procedure
1 Do one of the following:
•
If in a call, press
•
On the local interface, navigate to
2 Select Near or Far camera.
3 If you selected a camera that supports electronic pan, tilt, and zoom, you can adjust the
camera's position using your remote control:
•
Press or
•
Press the directional buttons to move the camera up, down, left, or right.
4 To store a preset position, press and hold a number from 0 to 9 for five seconds.
Any existing preset stored at the number you entered is replaced.
Related Topics
Camera Presets in Single Camera Mode
Move the Camera to a Stored Preset
After you have your presets stored, move the camera to one of the stored presets.
Procedure
1 If you are in a call, press Select on the remote control to switch between a near-end site (Your
Camera) or far-end site (Their Camera) camera.
2 Press a number on the remote control.
Printed from Polycom, Inc. (http://documents.polycom.com)
.
to zoom the camera out or in.
Cameras > Presets.
Page 50