Patton SmartNode 4740 Series User Manual page 26

SmartNode 4740 Series (16–32 Ports) User Manual
Button/LEDs/Ports
USB 2.0 Port
Console port
ETH 0/0 & ETH 0/1 Auto-MDX Gigabit Ethernet port, RJ-45 (see
ETH 0/0 & ETH 0/1
ports ACT LED
(green)
ETH 0/0 & ETH 0/1
ports GIG LED
(yellow)
Reset button
Applications
Table 3. SN4740 Series front panel descriptions
USB 2.0 host port (see
USB 3G/4G Cellular Modem. A list of supported USB Models can be
found in the release notes and in the Software Configuration Guide
Used for service and maintenance, the console port (see figure 2 on
page 18) an RS-232 RJ-45 connector, connects the product to a serial
terminal such as a PC or ASCII Terminal (also called a dumb terminal).
Configuration settings:
• 19200 bps
• 8 bits, no parity
• 1 stop bit
• flow control off
Figure 12), connects the unit to an Ethernet WAN device (for example, a
cable modem, DSL modem, or fiber modem).
On: Connected to network
Flashing: Network is active
Off: Not connected to network
On: Connected to network at 1 Gbps
Off: Connected to network at 10/100 Mbps or not connected to network
The reset button has several functions, as described in appendix F,
"Reset Button Functions"
Description
figure 11 on page 24 or figure
figure 11
on page 62.
2 • General Information
12) to connect a
on page 24 or
26