MaxFlight FS-VC Manual page 76

Command window. The operator must click on "Stop" before the "Lower" button will
be available. Click "Stop" then 'Lower" to bring the machine down.
Keyboard Commands
1. Press "F2" to open an Options window, on the "General" tab you can change the
ride time for the flight programs or enable or disable motion by checking or un-
checking the "Enable Motion" box. Disabling Motion allows you to test the
programs in the machine in the home lowered position with no motion.
2. Hold the "Alt" key and press "Enter", this will close any game that is open on the
Onboard Computer.
System Shutdown:
The machine must be shut down in a sequential procedure to insure the longevity of the
projector and computers. Never just turn off the power switches or breakers to shut down
the machine.
1. Press in the main power E-stop under the monitor to shut off power to all
inverters/motors.
2. Using the remote, turn the projector power off by pointing the remote to base of
projector and pressing the power button twice. NOTE: The projector fans will still run,
wait approximately 5 minutes before shutting off main power.
3. With the Command screen still open press "ALT & ENTER" on the keyboard at the
same time to close the game on the Onboard Computer.
4. VNC to the onboard computer; Open the Tight VNC icon and select Connect.
5. Once connected to the onboard click on "START", then "SHUT DOWN", then
"OK", this shuts off the computer. NOTE: You may have to hover the mouse over the
Taskbar to get it to pop up if it is on auto-hide.
6. Repeat shutdown procedure for the Kiosk/Stand-up and then the Motion Computer.
7. Turn A-frame power strip switch OFF.
(With Command window open):