Setup And Calibration Of Flight Sticks - MaxFlight FS-VC Manual

10. Make sure people are clear of rotation.
11. Click on +Jog icon, front of machine must go up. If OK or not OK click stop,
pitch motion stops. If correct go to 11-e and finish. If not 11-a.
a. If not correct motion, you must power down, wait @10 minutes, to allow
capacitors to drain.
b. Switch any two wires on bottom of pitch inverter and retighten set screws.
c. Pull out e-stop again to power up the system
d. Click on +Jog again if correct, click stop
e. Click on -Jog if correct, click stop and go to next inverter
12. Click on roll tab
13. Verify people are clear of rotation
14. Click +Jog machine must turn right. Reference is you sitting in the machine. If
OK or not OK click Stop. If correct go to 14-e and finish. If not 14-a.
a. If not correct motion, you must power down, wait @10 minutes, to allow
capacitors to drain.
b. Switch any two wires on bottom of roll inverter and retighten set screws.
c. Pull out e-stop again to power up the system
d. Click on +Jog again unit turns right, if correct, click stop
e. Click on –Jog, unit turns left, if correct, click stop, rotation test done
15. Close all tabs
16. Turn power off, push E-stop in.
17. Level and lower the unit manually.
2-8 Setup and Calibration of Joysticks and Throttle Controller Interface
Enabling and Calibrating Joysticks/Throttles running USB control Boards.
a. START (Window Icon) on task bar, select Control Panel, select
Gaming Options
b. Both USB adapters must be visible
c. Click on one or the other and select Properties
d. Click settings tab
e. Click Calibrate and follow Wizard instructions
f. Select Test and then Apply
56