How To Make A Programmable Coaster Track; Raising The Unit - MaxFlight FS-VC Manual

2-10C Initial Game Startup for Flight Sim X Program
1. To start a program click on big icons on the control panel window for correct program legend
you are about to run. Select an aircraft from drop down files to the right. The onboard will
load Flight Sim X program and cycle through all settings required.
2. When program is ready the "On-Board Dispatch Status window" will state Flight Sim X is
ready.
3. The files on right side will come back dark and airplane cockpit will be visible on the TV.
4. Load passengers
5. Verify seat belts and shoulder restraints are closed and fastened.
6. Explain the use of the flight controls.
7. Show location of panic e-stop push button and how to use it.
8. Explain use of green pilot transfer button on top front of center console.
9. Close and latch cockpit, G2E motion status will change to "Home"
10. Click on "Raise" machine goes to balance then goes on to the top. G2E status will change to
"Running" when machine is safe and up sensors are closed. System Control icons "Stop",
"Start", and "Pause" will come on dark. Lower icon will remain on until you click on
"Start" to run the game.
11. Click on "Start" and patrons now have control of the motion from inside. Lower icon goes
out.
12. When timer times out, unit will return to home level position and stop. System controls Raise
and Start go away and "Lower" icon comes back ON.
13. Click "Lower" and machine will lower to support stands.
14. Open cockpit, release restraints and allow people to exit.
15. Load new patrons and repeat above procedure at step 1.
2-10D How to make Programmable Coaster Track
1. Click on kiosk window using touch pad on front of kiosk
2. Type a name using the touch pad by clicking on the letters there
3. When you have the name, click on NEXT
4. Click on the coaster window in center, another window opens showing different tracks
5. You can select up to nine (9) tracks
6. Click on DONE when finished, the ride you just made goes to the operators control
panel when PROGRAMMED VIDEO ICON is selected.
2-10E Raising the Unit
Ensure that power is applied and normal program is loaded. Go to the LIFT
CONTROL, click on the "RAISE" icon. The unit will come up about 1.75 to 3.0 inches,
stops to balance. Upon completion of balancing, the unit will continue raising up to the
upper limit switches. If the unit does not balance within 65 seconds, the unit will lower
to down stops, you must open the cockpit and be politically correct when trying to change
weight of patrons.
NOTE: The weight limit is 500 pounds.
20