2-13 Emergency Stop Procedures; Occupant Using Their E-Stop Button Inside Cockpit - MaxFlight FS-VC Manual

NOTE! On some projector remotes you have a power OFF button, use it if available
to turn projector off.
4. R-Click on VNC icon select on-board computer IP address, click on CONNECT, on
board desktop now shows on the screen. Should programs still be running, shut them
down using the following steps:
a. R-click on onboard serial number icon on task bar.
b. Select "Send Control, Alt and Delete"
c. On on-board task manager, click "Applications" tab
d. Click on program listed and then click "End" at bottom.
e. After programs are shut down and desktop is visible continue.
5. Click START icon lower left side, then click on SHUTDOWN.
6. Verify kiosk computer is shut down.
7. Shut motion computer OFF, click START, then SHUTDOWN then
SHUTDOWN
8. Turn the A frame power strip OFF, by going through hole on side of A frame and
pressing the power switch in.
9. Go turn OFF power on Battery Backup, press hold power button till it beeps, then
release button.
10. Close all seat belts and put belts on shoulder harness
11. Place remote controls on top of motion computer.
12. Close curtain.
13. Machine is now secure

2-13 Emergency Stop Procedures

In the event of an emergency follow the procedures described below for the type of
emergency.
2-13A Occupant: Using the Panic Switch located inside cockpit
NOTE! When activated, a red dot light on top and a yellow window will appear
on right side of motion control program window, or a yellow window in
operator control window with legend stating what the issue is.
During the ride the patrons have the ability to initiate a ride abort by depressing the
Occupant Panic Switch. The Switch is located between patrons on front of the center console.
When this switch is depressed the ride will return to the "home" position, the video projector will
freeze and the sound will stop. On the operators panel they will get the information block to turn
yellow stating what happened. Operator must click on STOP icon top center on operator screen,
then the LOWER icon comes on. Once the unit is verified level, lower the unit by clicking the
"lower" icon on the computer screen. After the unit is completely lowered onto the stairway, open
the cockpit door, discharge the passenger following the Passenger Unloading Procedure.
22