2-10 Game Start Procedures; Initial Game Startup For Coaster Programs - MaxFlight FS-VC Manual

2-10 Game Start Procedures

2-10A Initial Game Startup for Coaster Program/s
1. To start a program click on big icons on the control panel window for correct program legend
you are about to run. Select a coaster from the drop down files to the right. The on-board will
load the selected program and cycle through all settings required.
2. When program is ready the "On-Board Dispatch Status window" will state Coaster (name)
loaded and ready.
3. The files on right side will come back dark and MaxFlight logo be on the TV screen.
4. Load passengers
5. Verify seat belts and shoulder restraints are closed and fastened.
6. Explain use of patron e-stop push button.
7. Click on "Raise" machine goes to balance then goes on to the top. G2E status will change to
"Running" when machine is safe and up sensors are closed. System Control icons "Stop",
"Start", and "Pause" will come on dark. Lower icon will remain on until you click on "Start"
to run the game.
8. Click on "Start", game video plays on TV, machine follows the motion. Lower icon goes out.
9. When timer times out, system controls Raise and Start go away and "Lower" icon comes
back ON.
10. Click lower and machine will lower to support stands.
11. Open cockpit, release restraints and allow people to exit.
12. Load new patrons and repeat above procedure at step 1.
2-10B Initial Game Startup for Combat Flight Sim 2 Program
1. To start a program click on big icons on the control panel window for correct program legend
you are about to run. Select an aircraft from drop down files to the right. The onboard will
load CFS2 program and cycle through all settings required.
2. When program is ready the "On-Board Dispatch Status window" will state CFS2 is ready.
3. The files on right side will come back dark and airplane cockpit will be visible on the TV.
4. Load passengers
5. Verify seat belts and shoulder restraints are closed and fastened.
6. Explain controls and show location of panic e-stop push button.
7. Close and latch cockpit, G2E motion status will change to "Home"
8. Click on "Raise" machine goes to balance then goes on to the top. G2E status will change to
"Running" when machine is safe and up sensors are closed. System Control icons "Stop",
"Start", and "Pause" will come on dark. Lower icon will remain on until you click on "Start"
to run the game.
9. Click on "Start" and patrons now have control of the motion from inside. Lower icon goes
out.
10. When timer times out, system controls Raise and Start go away and "Lower" icon comes
back ON.
11. Click lower and machine will lower to support stands.
12. Open cockpit, release restraints and allow people to exit.
13. Load new patrons and repeat above procedure at step 1.
19