DGC DC-5000 Instruction Manual page 6

UP key
Function 1 It is used to navigate the menus and increase values
while setting the parameters.
Function 2 In measurement mode, press this key to store the
current measurement reading.
DOWN key
Function 1 It is used to navigate the menus and decrease values
while setting the parameters.
Function 2 In the measurement mode, it is used as the calibration
Key. Put the probe in the air, press this key to
complete the calibration.
LEFT Key
Function 1 It is used to navigate the menus and decrease values
while setting the parameters.
Function 2 In A‐SCAN mode, press this key to enter CUSTOM
SETTING screen to open a setup that has been saved
before.
Function 3 In B‐Scan mode, press this key to control the thickness
reading indicator(the small yellow triangle).
RIGHT Key
Function 1 It is used to navigate the menus and increase values
while setting the parameters.
Function 2 In DIGIS and A‐SCAN mode, the readout will be
changed between mm to inch by pressing this key.
Function 3 In B‐Scan mode, press this key to control the thickness
reading indicator(the small yellow triangle).
‐ 4 ‐