Table of Contents
Advertisement
Limitation Mode
This function allows the user to set an audible and visual (Hi/Lo ) parameter
when measurements. If the measurement falls below or above the HI/LO
limits, set by the user, the red H or green L will be displayed and the beeper
sounded. This improves the speed and efficiency of the inspection process by
eliminating constant viewing of the actual reading displayed.
The following pages outline how to enable and set up this feature:
1) Press the
2) Use
Limitation is highlighted. Press the
shows as follows:
3) Use
be set as 0.000, 00.00 and 000.00. The 1
numbers 1‐9 as a circle. The 3
as a circle. Press the
4) Press the
measurements.
8.1.2 E‐E Mode
The E‐E (echo‐echo) function is not available owing to suitable probe is under
developing right now.
key into MEA.
keys to scroll through the sub menu items until
keys to set the low / high limitation. The value could
rd
key to confirm.
key to exit setting and DC‐5000 is now ready to perform
key to confirm. The display
st
and the last position can be set
positions can be set numbers 1‐9 and dot
‐ 14 ‐
Advertisement
Table of Contents
