Table of Contents
Advertisement
8.2.4 Measurement rate
The DC‐5000 performs measurement of 2 times/second and 10 times /
second. 2 times/second is quite adequate for single measurements. And 10
times/second is recommended to measure the high temperature surfaces.
The following steps outline how to enable and set up this feature:
1) Press the
2) Use
Measurement rate is highlighted.
3) Press the
key to confirm.
4) Press the
measurements.
8.2.5 Auto measurement
This feature is recommended to measure some basic materials. All
parameters are preset according to the different transducers. For A‐scan
mode, it is a convenient way to let DC‐5000 find the detection point and
bring the waveform signal into view automatically.
The following steps outline how to enable and set up this feature:
1) Press the
2) Use
Auto measurement is highlighted. Press the
3) Press the
displayed on the left down corner of screen.
key to illuminate SET
keys to scroll through the sub menu items until
or
key to select 2 times/S or 10 times/S. Press the
key to exit setting and DC‐5000 is now ready to perform
key to illuminate SET
keys to scroll through the sub menu items until
key to return to the measurement screen. There is Auto
‐ 21 ‐
key to confirm.
Advertisement
Table of Contents
