Difference Mode - DGC DC-5000 Instruction Manual

Difference mode:
In the quality Control environment, it is sometimes necessary to know the
difference between a nominal (target) thickness value and an actual
thickness value. With the Difference mode enabled, DC‐5000 will display
the positive ( + )or negative(‐) difference from an entered nominal value.
The following pages outline how to enable and set up this feature.
1) Press the
2) Use
Difference is highlighted. Press the
shows as follows:
3) Press the
4) Press the
value could be set as 0.000, 00.00 and 000.00. The 1
can be set numbers 1‐9 as a circle. The other positions can be set numbers
1‐9 and dot as a circle. Press the
Note: 500.0 is the Max. value can be set. If User sets the value exceeding
the max. value, the unit will correct it as 500.0 automatically.
5) Press the
key to illuminate MEA.
keys to scroll through the sub menu items until
or key to move the cursor,
or key to change the numbers and Dot position. The
key to exit and DC‐5000 is now ready to work.
key to confirm. The Display
key to confirm.
‐ 12 ‐
st
and the last position