Connecting The Outputs - Mircom TX3 Series Installation And Operation Manual

3.5

Connecting the Outputs

There are 8 outputs located on the top right hand corner of the Card Access
Controller as shown in figure 9.
Each output is wired for a specific function or for an active state. Determine the
functional requirements for the device and connect the outputs accordingly. For
additional details and a complete description of the different types of
configurable functions see section 2 on page 13.
After the installation and setup is complete, the functional state of all outputs
must be configured using the Configurator software.
3.5.1 Specific functions
Each output is wired for the following specific functions:
•
•
•
Lock for reader A or B. This output assigns the main access door to either reader
A or reader B. When access is granted at the designated reader, this output
unlocks the door.
Handicap lock for reader A or B. This output controls the handicap access
door. Access is granted to cards with handicap privileges.
General purpose output. The general purpose output is for all other types of
outputs, such as turning on a light.
3.5.2 Active state
Outputs require active states. Each output is configured for the active state to
indicate one of the following:
•
•
3.5.3 Outputs 1 to 6
Outputs 1 to 6 are relay contact programmable outputs with the following
characteristics. Figure 18 shows a sample connection.
•
•
TX3-CX Card Access System Installation and Operation Manual
40
LT-980 Copyright 2017
Lock for Reader A or B
Handicap lock for Reader A or B
General purpose output
energized
de-energized
normally open (NO)
normally closed (NC) available
Installation and Setup of the Card Access Controller
Version 4.1