Connecting The Inputs - Mircom TX3 Series Installation And Operation Manual

3.4

Connecting the Inputs

Each Card Access Controller has eight inputs to accommodate the different types
of configurable functions associated with the inputs. For additional details and
a complete description of the different types of configurable functions see
section 2 on page 13.
After the installation and setup is complete, the functional state of all inputs and
circuit supervision types must be configured using the Configurator software.
During configuration you will also establish correlations between inputs and
outputs.
Depending on the device each input is configured according to:
•
•
•
•
INPUT 1
INPUT 2
Figure 13. Controller Board Input Terminals
3.4.1 Inputs 1 to 8
Inputs 1 to 8 are programmable inputs. Configure each input for one of the
following actions. Figure 14 shows a sample connection.
•
•
•
•
•
TX3-CX Card Access System Installation and Operation Manual
36
LT-980 Copyright 2017
type of input function
active state
supervision requirement
alarm delay
INPUT 3 INPUT 4 INPUT 5
Request to Exit (reader A)
Request to Exit (reader B)
Door sense (reader A)
Door sense (reader B)
General purpose input
Installation and Setup of the Card Access Controller
INPUT 6 INPUT 7 INPUT 8
Version 4.1