Mircom TX3 Series Installation And Operation Manual page 17

2.3.1 Lock / Unlock
An access point has one of the following lock status modes:
Lock Mode. When in lock mode the door is normally locked. Any valid access
card unlocks the door for the duration of a specified time interval according to:
•
•
During this mode the red LED on the card reader associated with this access point
becomes active and turns green for the duration the door is unlocked.
Unlock Mode. When in unlock mode the door is unlocked. The green led on the
reader associated with this access point stays lit. During this mode the door sense
is not monitored for the following:
•
•
•
2.3.1.1 Changing the lock/unlock mode
The lock/unlock mode is changed in one of the following three ways:
•
•
•
Whenever the mode is changed from lock to unlock or from unlock to lock, the
beeper on the reader associated with this access point sends a distinct beep
indicating the mode is changed.
2.3.2 High security
The high security mode grants access to cards with the high security privilege.
This mode is changed as follows.
•
•
TX3-CX Card Access System Installation and Operation Manual
Version 4.1
LT-980 Copyright 2017
door unlock time
extended unlock time
door did not open
door held open warning
force entry alarm
an administrator using the Configurator can send a command to change the
lock mode
an access card with lock/unlock privileges, if swiped twice in succession,
toggles between lock and unlock mode
a schedule associated with the lock/unlock mode - when the associated
schedule is active, it changes to unlock mode and when the schedule is
inactive, it changes back to lock mode
if the access point is configured as high security then it is in high security
mode by default unless changed by the PC or card with high security
privilege
if an access card with high security privilege is swiped four times in
succession, the mode toggles between high security on to high security off
Configurable Features
17