Mitsubishi Electric CC-Link IE-NZ2GNSS2-8D User Manual page 148

■Input dark test execution setting
Set whether to perform the input dark test function of the diagnostic function in the safety remote I/O module in units of 1
point.
Module
Input module
Output module
I/O combined module
When "Wiring selection of input" is set to "0: Not used" or "3: General single", this parameter is ignored.
■Input dark test pulse OFF time setting
Set the width of the OFF pulses that the terminals T0 and T1 output, on a module-by-module basis.
Module
Input module
Output module
I/O combined module
When "Wiring selection of input" is set to "0: Not used" or "3: General single", or when "Input dark test
execution setting" is set to "1: Do not perform", this parameter is ignored.
■Number of pulse output for input dark test
Set the number of pulse output for input dark test on a module-by-module basis.
Module
Input module
Output module
I/O combined module
When "Wiring selection of input" is set to "0: Not used" or "3: General single", or when "Input dark test
execution setting" is set to "1: Do not perform", this parameter is ignored.
APPX
146
Appendix 4 Remote Buffer Memory
Address (hexadecimal) Name
0160H to 0167H Input dark test execution setting X0 to X7

0160H to 0167H
Address (hexadecimal) Name
0170H Input dark test pulse OFF time

0170H
Address (hexadecimal) Name
0171H Number of pulse output for input dark
test

0171H
Setting range
0: Perform
1: Do not perform
Setting range
0: 400s
1: 1ms
2: 2ms
Setting range
0: 1 time
1: 2 times
2: 3 times
Default value
0: Perform
Default value
0: 400s
Default value
0: 1 time