Mitsubishi Electric CC-Link IE-NZ2GNSS2-8D User Manual page 52

Installing or removing the terminal block
The following procedures show how to install and remove the terminal block.
■Lock and release lever positions
To make it easy to install and remove the terminal block, a three-stage positioning stopper is attached so that the lever does
not freely turn around.
When installing or removing the terminal block, turn the lever to the lock or release lever position.
View from the right side of the safety remote I/O module: When pulling the
terminal block
(2)
(1)
View from the right side of the safety remote I/O module: When the terminal
block has been inserted
(1)
(2)
■Removal procedure
Turn the lever to the release lever position and remove the terminal block from the safety remote I/O module.
■Installation procedure
Move the lever to the locking lever position and push in the terminal block. When the terminal block is fully pushed in, the hook
of the lever hangs on the safety remote I/O module and fits the terminal block.
The terminal block can be inserted with the lever locations other than the lock lever position.
After insertion, check that the lever is in the lock lever position.
6 INSTALLATION AND WIRING
50
6.6 Wiring of External Device and I/O Terminal Block
1.
Release lever position
This lever position shows the state in which the terminal
block (1) has been completely pulled out from the safety
remote I/O module. Turn the lever from the lock lever position
to the release lever position (2), and lift the terminal block
from the safety remote I/O module.
2.
Lock lever position
This lever position shows the state in which the terminal
block (1) is completely fitted to the safety remote I/O module.
Check the lock lever position (2) and pull the terminal block
lightly to check that the terminal block is completely fitted to
the safety remote I/O module.