Mitsubishi Electric CC-Link IE-NZ2GNSS2-8D User Manual page 146

■Safety approval code
Set a value that identifies the individual safety remote I/O module. Set a value that does not overlap with those of other safety
remote I/O modules, such as a MAC address.
*1 When setting a MAC address, set the lower eight digits of the MAC address.
Address (hexadecimal)
0002H
0003H
■Communication speed setting
Set a communication speed with which the safety remote I/O module links up.
Address (hexadecimal)
000BH
Parameter data per module
■Wiring selection of input
Set the input wiring method in units of 1 point.
Module
Input module
Output module
I/O combined module
• When "Wiring selection of input" Xn (n: even number) is set to "1: Safety double wiring (NC/NC)", Xn+1, the
partner of Xn, is automatically set to "1: Safety double wiring (NC/NC)", and no other settings are possible.
• When Xn (n: even number) in "Wiring selection of input" is set to "0: Not used", "2: Safety single", or "3:
General single", set Xn+1, the partner of Xn, to other than "1: Safety double wiring (NC/NC)". When "1:
Safety double wiring (NC/NC)" is set, a parameter data error (wiring selection of input) (error code: 0560H)
occurs when "Write to PLC" is executed.
• For unused input terminals, set "0: Not used" in "Wiring selection of input".
• When "Fast logic pattern setting" is set to other than "0: Not used", this parameter is ignored.
■Input response time
Set the input response time of the input signal in units of 1 point.
Module
Input module
Output module
I/O combined module
• Select a longer time than the input dark test pulse OFF time for the parameter. When "1: Do not perform" is
selected for "Input dark test execution setting", a shorter time than the input dark test pulse OFF time can be
set for the parameter.
• When "Wiring selection of input" is set to "0: Not used", this parameter is ignored.
APPX
144
Appendix 4 Remote Buffer Memory
*1
Name
Safety approval code (lower 16 bits)
Safety approval code (upper 16 bits)
Name
Communication speed setting
Address (hexadecimal) Name
0110H to 0117H Wiring selection of inputs X0 to X7

0110H to 0117H
Address (hexadecimal) Name
0120H to 0127H Input response time X0 to X7

0120H to 0127H
Setting range
00000000H to FFFFFFFFH
Setting range
0: 1Gbps
1: 100Mbps
2: Automatic
Setting range
0: Not used
1: Safety double wiring (NC/NC)
2: Safety single
3: General single
Setting range
0: 1.0ms
1: 1.5ms
2: 5ms
3: 10ms
4: 20ms
5: 50ms
6: 70ms
Default value
FFFFFFFFH
Default value
0: 1Gbps
Default value
0: Not used
Default value
0: 1.0ms