Table of Contents
Advertisement
CHAPTER 4: COMMUNICATION
After completion of parameterization, the data must be sent to the master component by means of a download.
The menu item ´Online` and ´Start Debug Mode` is to be used to check whether the EntelliPro ES has accepted the parameters.
If all lines are green, the communication is free from defects. If lines to slaves are red, the cause can be found through an
extended diagnosis.
EPOS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
4.56
Advertisement
Table of Contents
Need help?
Do you have a question about the EntelliPro ES Series and is the answer not in the manual?