Table of Contents
Advertisement
GE Industrial Solutions
EPOS Motor Management System
Chapter 6: EntelliPro CP3 and CP5 application
6.1 EntelliPro CP3 Main panel
The EntelliPro CP3 device is a touch control display integrated into the Motor Control Center MCC for local control; alarm
handling; and visualization the device status, values, and parameter settings.
EntelliPro ES parameters cannot be set via the main panel.
The EntelliPro CP3 application has been created to operate and handle the 11 pre-programmed drive typical, such as DOL , DOL
Reverse, Star Delta, Star Delta reverse, Soft starter, Soft starter reverse, Breaker control, Dahlander, Pole changing starter, Solenoid
valve, and Actuator.
NOTE:
If the drive typical value is set to "Fully free logic," the Modbus data interface of the free logic must follow the EntelliPro ES
standard. Otherwise the data in the EntelliPro CP application might be incorrect.
The next two figures show the Entellipro CP3 main panel and parameters descriptions.
EPOS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
2 : Valve 1
local
operate
CHAPTER 6: ENTELLIPRO CP3 and CP5 APPLICATION
6.1
Advertisement
Table of Contents
