Table of Contents
Advertisement
5.1.2 Slave Device Configuration
To add a slave devices in the system, select the file menu, click configuration, and then click device configuration.
Check the edit box and the EntelliPro ES button on the WinESG device configuration panel. Double click on the slave
address number to select the device(s) to be added. A blue highlighted address indicates the device is selected for
configuration with WinESG. To disable a selected device click on its address. Click ok when completed.
To add additional Bus line, check edit box, then right click on the existing Bus line (PROFIBUS1.). A pop up menu will appear
that allows for the addition.
Figure 5-2 shows the WinESG slave configuration panel.
WinESG slave configuration panel
Figure 5-2:
NOTE:
For WinESG device control and data visualization, the profibus-DP devive must be included in the OPC Server
configuration.
EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: Wi nE S G
5.6
Advertisement
Table of Contents
