GE EntelliPro ES Series Installation And Instruction Manual page 83

Refer to Tables 2-6 and 2-7 for the complete input, output, timer and control configurations of the Dahlander
motor starter.
Figures 2-24 and 2-25 show typical Dahlander starter diagrams for EntelliPro ES3 and EntelliPro ES5.
If the default configuration and the Dahlander typical are selected in the WinESG parameterization/information
panel shown in the illustration below or by setting Modbus function code 6 register 62 bit0 to 1 and bits 8,9,10
and 11 to 0x6,the inputs and outputs are mapped as below:
For EntelliPro ES3 types:
Input 99 is mapped to contactor 1 feedback
Input 98 is mapped to contactor 2 feedback
Input 97 is mapped to contactor Y feedback
Input 96 is mapped to main circuit feedback
Input 95 is mapped to emergency stop
Input 94 is mapped to external supervision
Input 93 is mapped to safety circuit
Output 41 is mapped to contactor 1
Output 43 is mapped to contactor 2
Output 45 is mapped to contactor Y
For EntelliPro ES5 types:
Input 99 is mapped to contactor 1 feedback
Input 98 is mapped to contactor 2 feedback
Input 97 is mapped to contactor Y feedback
Input 96 is mapped to drawer in test mode
Input 95 is mapped to drawer in operation mode
Input 94 is mapped to main circuit feedback
Input 93 is mapped to control circuit
Input 11 is mapped to command OFF
Input 12 is mapped to command slow ON1
Input 13 is mapped to command fast ON2
Input 14 is mapped to external supervision
Input 15 is mapped to reset alarm
Input 16 is mapped to emergency stop
Input 17 is mapped to safety circuit
EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 2: INSTALL ATION/CONFIGURATION
- active high
- active high
- active low
- active low
- active low
- active high
- active low
- active high
- active high
- active high
- active high
- active high
- active low
- active low
- active low
- active high
- active high
- active high
- active high
- active low
- active low
2.58