Table of Contents
Advertisement
CHAPTER 6: ENTELLIPRO CP3 and CP5 APPLICATION
6.
EntelliPro CP5 installation
The EntelliPro CP5 has three communication (COM) ports on the back side. The communication port COM3 is used
for the Modbus communication with the EntelliPro CP5 application. Pin3 of the COM3 port is the Modbus DataP
signal and Pin6 is the DataN signal.
A complete description of the EntelliPro CP5 panel can be found in the WEB - www.beijerelectronics.com.
6.18
Application downloads are done via the COM1 port.
EPOS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
Advertisement
Table of Contents
