Set Communication - ADF Web HD67908-5-A1 User Manual

Industrial Electronic Devices

SET COMMUNICATION:

This section define the fundamental communication parameters of HART and Modbus
buses.
By Pressing the "Set Communication" button from the main window for SW67908 (Fig.
2) the window "Set Communication" appears (Fig. 3).
The means of the fields for the "HART Master" section are:
In the field "Address" the type of Master is defined;
In the field "Retry Limit" the maximum number of retries in case of missing
response from HART device is defined;
The means of the fields for the "Modbus Slave" section are:
In the field "Baudrate" the baudrate for the serial line is defined;
In the field "Parity" the parity of the serial line is defined;
In the field "Stop Bits" the number of Stop Bits of the serial line is defined;
In the field "ID Device" the ID of Modbus side of the converter is defined (only if
"Asynchronous" mode is set);
If the field "Read with Input Register / Status
possible to read the data from HART side with Input Registers (Function 04) and
write the data to publish on HART side with Holding Registers (Function 06/16). The
Output data are readable with Function 03. Otherwise, only Holding Registers will
be used and the Output data of HART side cannot be read back.
ADFweb.com S.r.l.
Document code: MN67908_ENG
Function" is checked, it is
User Manual Modbus Slave / HART Master
Revision 1.001
Figure 3: "Set Communication" window
Page 17 of 32